RotoView Data
View/Setup
The Data View/Setup window monitors the communication with the RotoView sensor
unit. Use this window to evaluate the raw sensor data and troubleshoot the
connection. To view the Data View/Setup window, click on the Expand/Contract
button 
(if you are not already in Expanded Mode), and then click on the
Data View/Setup
button. Or, right-click anywhere on the Main Module and select Data
View/Setup.
The following
window should appear:
The Data View/Setup window lets you control the
red and green LEDs provided on the RotoView unit, change Timer 2 and Timer 3
settings, change the number of ADC samples, and change the polling interval
that the RotoView Development System refreshes its data from RotoView.
Click on the
checkboxes to turn on/off the red and green LEDs on the RotoView unit. This is
a good way to see that RotoView and your PC can communicate. Of course, you
must have a USB connection established to communicate.
Timer 2 controls
the rate at which an ADC sample is performed. The default setting is 5 mS
(milliseconds). You can change the Timer 2 rate by entering a number between 0
and 65, and then clicking on the Set button. Timer 3 controls our
"ticker" rate, which is labeled as T in the Data box. The default
setting for Timer 3 is 10 mS. You can change the Timer 3 rate in the same
fashion as Timer 2. The range for Timer 3 is also 0 to 65 mS.
The ADC Average
control lets you get more accurate and stable values from your RotoView unit.
The default setting is 1 sample per RotoView Development System poll.
The Polling box
allows you to change the rate that the RotoView Development System communicates
with RotoView.
Save (*.log) files
so you can view and print the raw data sent to your PC. The (*.log) files are
important for research and assist in technical support.
Related Links:
· RotoView Response Graph
Editor
Quick Start